Hoping to save some money when repairing your Wolverine Brush Cutter gear box?
Here is a video made by Makers Acres showing how it can be repaired.
https://www.youtube.com/watch?v=f7CZFcEl8e8
They have a list of parts in their video description. I have also included it here for your benefit.
Seals:
TC35x72x10 https://amzn.to/4cLCYqr
TC40x80x12 https://amzn.to/4aNH2oj
EC52x7 https://amzn.to/4apRwtu
Bearings:
NSK 6205 - 25MM x 52MM x 15MM https://amzn.to/4apmqD3
NSK 6207 - 35MM x 72MM x 17MM https://amzn.to/4cAoMA8
NSK 6208 - 40MM x 80MM x 18MM https://amzn.to/3IS2ht5
Shims & Retaining Rings: Hopefully you can reuse the shims and retaining rings. If not you will need to find a similar one below. Unfortunately I don’t have the exact part numbers. If one of you get me some measurements I can try to identify what parts you need.
40mm Shims https://www.mcmaster.com/catalog/128/3571
Retaining Rings https://www.mcmaster.com/catalog/128/3606
Tools:
Seal Remover: https://amzn.to/3xa8qOB
Retaining Ring Pliers: https://amzn.to/4cy7kfO
Misc Supplies
Gear Oil: https://amzn.to/3IgmolE
Rust Reformer: https://amzn.to/3vlT60X
Silicone Gasket: https://amzn.to/3VvYHfH
If the gears themselves are slightly damaged you might be able to clean them up like the guy in the video. Otherwise if you could send me some pictures and a few measurements I might be able to find replacement gears as well.
Sound intimidating?
If you would rather just purchase a gear box you can find one on the following page that is supposed to be a drop in replacement. https://www.honeymilkhomestead.com/blog/6ft-skidsteer-brush-cutter-upgrade-amp-repair
Note: When you click links to various merchants on this site and make a purchase, this can result in this site earning a commission.